I have the PST front end kit. I doubt the ball joints included were made by
PST. They are probably someone elses. Who's I dont know. I don't remember
any label on them other than a number.
Be carefull lubing poly bushings or they'll squeak like a crate of crickets.
mm
>
> Bill brought up a question that I wanted to ask. Has anybody used the
> poly graphite bushings and ball joints? Even if it's felt that the Moog
> ball joints are better I am having a hard time finding the heavier duty
> ones and need part numbers for those. I am looking at going this route
> but I am curious if anybody has had experience with them both. Looking
> for the pros/ cons to each and how they compare to each other.
>
> On another note there is always a lot of talk about brakes but it seems
> almost none for the Gen II's. What are you guys running for front rotors
> and pads on a Gen II? I am looking for good brakes since the last set
> warped after only 25K on them. I also can tell that I have a caliper
> dragging a little (which I know contributed to the warping) that I have
> to either replace or rebuild. Any recommendations there?
>
> Jeff Durling
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:35 EST