Do you know what the proper voltage should be? Can you describe how to
check?
I've never checked this before...
Chris
""John Bell"" <john_bell_2@hushmail.com> wrote in message
news:be52ao$om6$1@bent.twistedbits.net...
>
> Check the voltages on your TPS. Sounds similar to the problem I had when I
> had my TB reinstalled after getting it machined.
> --
> John Bell
> '00 QC SLT+ 4x4 5.9 46RE NV242 3.92LSD
>
> ""Dakota Mailing list Member"" <creck@insightbb.com> wrote in message
> news:be4t8s$ia6$1@bent.twistedbits.net...
> >
> > Happy 4th!!! Help celebrate America by blowing a little piece of it up!
> > :-)
> >
> >
> > Hi all. I am at my brothers this weekend putting on the ported V8
> Throttle
> > Body on my V6 and need help. I have the new TB installed, with the
gasket
> > and V8 cable (not the S screw yet) and a homemade K&N air filter. I
need
> > help to determine why I can't get it to shift gears. I have a three
hour
> > drive to get home Sunday and hope to fix it by then. I don't want to
have
> > to take it back off.
> >
> > After breaking it in, I floor it and it runs strong, but it doesn't
shift
> > properly. If I'm driving normally, it shifts fine.
> >
> > I used the Trottle Body bracket from the V8 model and not the V6. The
TB
> > cable has no slack. It closes on idle and opens vertically when I mash
> the
> > pedal.
> >
> > I have the TB cable hooked into the inside snap clip and the other one
> > coming from the back on the outside snap clip.
> >
> > What can I check?
> >
> > Thanks!
> >
> > Chris Reck.
> >
> > 99 Sport V6 4x4
> >
> >
>
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:35 EST