Check the voltages on your TPS. Sounds similar to the problem I had when I
had my TB reinstalled after getting it machined.
-- John Bell '00 QC SLT+ 4x4 5.9 46RE NV242 3.92LSD""Dakota Mailing list Member"" <creck@insightbb.com> wrote in message news:be4t8s$ia6$1@bent.twistedbits.net... > > Happy 4th!!! Help celebrate America by blowing a little piece of it up! > :-) > > > Hi all. I am at my brothers this weekend putting on the ported V8 Throttle > Body on my V6 and need help. I have the new TB installed, with the gasket > and V8 cable (not the S screw yet) and a homemade K&N air filter. I need > help to determine why I can't get it to shift gears. I have a three hour > drive to get home Sunday and hope to fix it by then. I don't want to have > to take it back off. > > After breaking it in, I floor it and it runs strong, but it doesn't shift > properly. If I'm driving normally, it shifts fine. > > I used the Trottle Body bracket from the V8 model and not the V6. The TB > cable has no slack. It closes on idle and opens vertically when I mash the > pedal. > > I have the TB cable hooked into the inside snap clip and the other one > coming from the back on the outside snap clip. > > What can I check? > > Thanks! > > Chris Reck. > > 99 Sport V6 4x4 > >
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:35 EST