Re: Torque Spec on Header Bolts

From: DAKSY (rsmith13@nycap.rr.com)
Date: Sat Aug 09 2003 - 10:16:58 EDT

Next message: jdurling@bellsouth.net: "Re: 2004 Dakota update!!!"
Previous message: Bob Tom: "Re: P0161"
In reply to: the Runde's: "Torque Spec on Header Bolts"
Next in thread: the Runde's: "Re: Torque Spec on Header Bolts"
Reply: the Runde's: "Re: Torque Spec on Header Bolts"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Hey, Leslie & Steve

<snip>All we are needing now is the torque spec for the header bolts<snip>

The 2K FSM says that all studs & bolts on the exhaust manifold are to be
torqued to 18 lbs/ft. It also says to install the lower ones first
(loosely), drop the vehicle & then install the uppers. Tighten all of them -
starting at the center & working outwards...

HTH,

Bob Smith (DAKSY2K on AIM)
Averill Park, NY
2K DAK SY CC Sport + V6 4X4 5 Speed

WebPage URL: http://home.nycap.rr.com/daksy/

Next message: jdurling@bellsouth.net: "Re: 2004 Dakota update!!!"
Previous message: Bob Tom: "Re: P0161"
In reply to: the Runde's: "Torque Spec on Header Bolts"
Next in thread: the Runde's: "Re: Torque Spec on Header Bolts"
Reply: the Runde's: "Re: Torque Spec on Header Bolts"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:46 EST