I'll see if i can get a pic. there is one on my site of the kit. Truck is a
little low to crawl under now so I'll see what i can do. I have had mine on
for 2 years now with no problems
""Chad Evans"" <hemidak@msn.com> wrote in message
news:BAY4-DAV113WgDS7GXP0003d4bc@hotmail.com...
>
> Chris how are the welds on the mbrp system ?
> The muffler specifically ?
> Would it be possible to get a pic from yours or a customers. the muffler
> that is.
>
>
> ----- Original Message -----
> From: "Chris Lambert" <chris@dakotausa.com>
> To: <dakota-truck-moderator@bent.twistedbits.net>
> Sent: Wednesday, September 17, 2003 7:55 AM
> Subject: DML: Re: Exhaust Systems II
>
>
> >
> > The MBRP Split Dual is what you want. It is 100% bolt on. I did mine in
> > less
> > than an hour. Just take the factory stuff off and bolt on the new. Works
> > fine withup to a 31" spare contact me
> >
> >
> >
> > "Brian Mingle" <bsm11@cornell.edu> wrote in message
> > news:5.2.1.1.2.20030917083101.00a7cdf8@postoffice9.mail.cornell.edu...
> > >
> > > I should clarify what I am looking for. I know there are tons of
single
> > > pipe applications for my truck, but I am looking for a dual cat back
> > system
> > > like Gibon's Dual Split Rear exhaust. My ultimate goal is to put a set
> > > of
> > > Gibson headers on it, and run duals out the back, but money is tight.
If
> > > I
> > > could find a decent dual outlet cat back system for my truck, that
> > > doesn't
> > > need a lot of fabricating, that would be great. One of the guys on the
> > list
> > > is actually looking up some stuff for me, but it never hurts to have
> > > more
> > > than one source. ;-)
> > >
> > > Thanks
> > >
> > > Brian
> > >
> >
> >
> >
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:58 EST