Michael Maskalans <mike-lists@tepidcola.com> wrote:
[...]
: I can't do the IAT relocate that I was planning, though, since even
: with the extensive hardware selection they had, there were no superfine
: metrics - I need a 14mm x 1.25 bolt to plug the hole in the manifold
: and a nut to put on the back side of the sensor in the K&N....
I have some IAT nuts here (I sell them in my MPI intake install
kits which require an IAT relocate). I don't have a 14mm x 1.25
plug, but I'm almost certain Autozone would have one. I purchased
a couple of O2 sensor plugs from them and they had a fine selection
of different plugs available. There is also a hardware store near
me which has all sorts of "weird" stuff that the usual stores
don't carry, they may have something. There is also a Home Depot
which might have something.
--
-Jon-
.-- Jon Steiger ---- jon@dakota-truck.net or jon@jonsteiger.com --.
| 1970 Barracuda - 1990 Dakota 'vert - 1992 Ram 4x4 - 1996 Dakota |
| 1996 Intruder 1400 - 1996 Kolb FireFly - 2001 Ram QC 3500 CTD |
`------------------------------------ http://www.jonsteiger.com --'
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:04 EST