""RayB"" <bpracing@worldnet.att.net> wrote in message
>
> One solution for the front bolt pattern is to send your rotors (or a pair
of
> new ones if you need them) over to Moser and have them plug and redrill
them
> for the 5 on 4.5 bolt pattern. Costs about $75 and you'll have them back
> within the week.
> http://www.moserengineering.com/moser_interior/shopservices.htm
>
>
> RayB
> http://www.dragtruk.com/ENTRIES/20KM1FD2KWBP.html
That works great with a gen I or gen II, but the gen III has slide on rotors
(sort of like a fwd car) and you'd have to have them fill and drill the
wheel hub as well.
It might be cool if the hubs for the Ram fit on the dakota spindles. Then
you'd only have to redrill the axles in the rear.
-- - Josh Lowered 2000 Dakota CC 3.9L www.geocities.com/lenny187/dakota.html www.omg-stfu.com
This archive was generated by hypermail 2b29 : Sat May 01 2004 - 12:00:16 EDT