One solution for the front bolt pattern is to send your rotors (or a pair of
new ones if you need them) over to Moser and have them plug and redrill them
for the 5 on 4.5 bolt pattern. Costs about $75 and you'll have them back
within the week.
http://www.moserengineering.com/moser_interior/shopservices.htm
RayB
http://www.dragtruk.com/ENTRIES/20KM1FD2KWBP.html
> -----Original Message-----
> From: owner-dakota-truck@bent.twistedbits.net
> [mailto:owner-dakota-truck@bent.twistedbits.net]On Behalf Of Bernd D.
> Ratsch
> Sent: Wednesday, April 14, 2004 6:46 AM
> To: dakota-truck@dakota-truck.net
> Subject: RE: DML: RE: Bolt Circle Change
>
>
>
> That's going to be tough. Since the hubs/bearings are a one-piece
> design, I don't think that any of the other 5-bolt versions will fit
> properly. I'll check at work as I have access to quite a few different
> hub models.
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@bent.twistedbits.net
> [mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Wayne
> Sent: Tuesday, April 13, 2004 8:59 PM
> To: dakota-truck@dakota-truck.net
> Subject: Re: DML: RE: Bolt Circle Change
>
>
>
> Actually I am working on a Dana 60 for the back, it is
> the front I am hoping to find an easy swap for. The
> truck is 2WD.
>
This archive was generated by hypermail 2b29 : Sat May 01 2004 - 12:00:16 EDT