So do I bob. I am getting tired of putting the truck on jack stands, and
getting on my creeper. its murder on your arms and shoulders.
I will check the fuses area. also I will check the connecter that is on top
of the tranny.
thanks.
----- Original Message -----
From: "Bob Tom" <tigers@bserv.com>
To: <dakota-truck@dakota-truck.net>
Sent: Sunday, April 18, 2004 8:33 AM
Subject: Re: DML: Help!! engine trouble code
>
> At 09:42 PM 4/17/04, chad wrote:
> >I have been have been getting engine code P0753
> >for a while now. I have replaced the O/D solenoid,
> >Tran governer transducer sensor (not sure of the name
> >but its close), and also the speed sensor for good measure.
> >what are sensors in the tranny that are causing the code.
>
> It could either be an open or shorted circuit in the O/D solenoid
> or its circuit. How you determine which one I don't know.
>
> If a shorted condition, look for a blown fuse.
>
> If a open condition, you'll need a scanner capable of doing
> bi-directional tests so as to manually operate the solenoid.
> If the test works then suspect a faulty solenoid. Most
> likely not the case since you've put a new one in. If test
> works then suspect a circuit fault.
>
> Sure hope that it's a shorted condition.
>
> Bob
>
>
This archive was generated by hypermail 2b29 : Sat May 01 2004 - 12:00:17 EDT