I like the over-the-frame idea. As I was laying under the truck on Sunday I
thought that perhaps it might hang too low if they went under the frame.
However, the below-the-frame setup might be much simpler and expedient
requiring only a few simple bends to make it look right. What do you think?
I would be willing to buy a set of nicely-bent exit pipes! Do the gen2 and
gen3 setups differ that much? Do you have any pics, Scott?
>Dont the gen 3 exit pipes bend over top of the frame on the side exit set
>up? I know the ram ones in your kits do not, those may look good on a gen
>2.
>
>Greg Conner
>We can sell just the exit pipes...
>
>
>
>Scott
>
This archive was generated by hypermail 2b29 : Tue Jun 01 2004 - 10:59:12 EDT