Check with www.gsmmotorsports.com They have a twin outlet pass side exhaust
setup that is a bolt in.
TonyC
-----Original Message-----
From: Pindell, Timothy <TPindell@OTTERBEIN.EDU>
To: 'dml@dakota-truck.net' <dml@dakota-truck.net>
Date: Tuesday, May 11, 2004 10:37 AM
Subject: Re: DML: side-exit exhaust
>
>I like the over-the-frame idea. As I was laying under the truck on Sunday
I
>thought that perhaps it might hang too low if they went under the frame.
>However, the below-the-frame setup might be much simpler and expedient
>requiring only a few simple bends to make it look right. What do you think?
>I would be willing to buy a set of nicely-bent exit pipes! Do the gen2 and
>gen3 setups differ that much? Do you have any pics, Scott?
>
>>Dont the gen 3 exit pipes bend over top of the frame on the side exit set
>>up? I know the ram ones in your kits do not, those may look good on a gen
>>2.
>>
>>Greg Conner
>
>
>>We can sell just the exit pipes...
>>
>>
>>
>>Scott
>>
>
This archive was generated by hypermail 2b29 : Tue Jun 01 2004 - 10:59:12 EDT