That makes a lot of sense, although I admit that I'm disappointed by the
potential loss of the cool-factor. <sigh> But it would be cheaper. If that
is the case that the collectors should be the same length, then the
logistics of that installation may not be feasible for a home mechanic w/o a
welder and more expensive for a shop to do it than my monthly allowance will
permit. The included-but-optional flange for the header y-pipe is 3". Would
3" be reasonable?
Tim
>Also, the typical position for an X or H is to be equal distances from the
header collectors. I wonder how much benefit you will get when the pipe from
the drivers side
>is a foot or more longer than the one from the passenger side. Seems to me
that it would mess up the exhaust pulse timing and negate any scavenging
effect.
>
>I think I would just go with a large diameter mandrel bent exhaust with a
high flow single cat and a muffler of your choice.
>
>Dave Clement
>99 SLT+ CC 4x4
This archive was generated by hypermail 2b29 : Tue Jun 01 2004 - 10:59:13 EDT