It's pressed in but by hand only, not machine. If it's hard to remove it's
because of time. When it comes out, use a new o ring and push it back in.
Hope this helps,
James
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of David Henry
Sent: Saturday, August 07, 2004 4:04 PM
To: dakota-truck@dakota-truck.net
Subject: Re: DML: Water Pump Return Line
It's a press fit. Can't get at the inside unless I saw a piece of the water
pump off. It's been soaking in P'Blaster [Official soaking oil of the DML]
since just before my first post. If it doesn't come out now It looks like
it's time for a water pump BBQ.
David
----- Original Message -----
From: Josh <root@omg-stfu.com>
To: <dakota-truck-moderator@bent.twistedbits.net>
Sent: Saturday, August 07, 2004 2:32 PM
Subject: Re: DML: Water Pump Return Line
>
> How is it secured into the waterpump? Does it look like it's pressed
> in or something? Maybe you can drive it out from the inside? Have
> you tried heating it and twist-pulling it out? Good luck!
>
> - Josh
> (trying to use pine for loonix)
This archive was generated by hypermail 2b29 : Wed Sep 01 2004 - 00:53:40 EDT