Don't remember the year of your truck, but check out the hub assemblies too.
I just done basically a complete frontend drivetrain/steering overhaul with
in the last tfew months, less the parts you were wondering about because I
never wrote them done. I have put in since may, all new ball joints, all
new tie rods, reman CVs and new hub assemblies.
The hub assemblies and CV took me about 3 1/2 to 4 hours to do in my
driveway.
Bill Day
billday@consolidated.net
http://users.consolidated.net/billday/
A rich man isn't always wealthy, he just has all the love he wants and can
give..
AIM - BadManD73 (Catch me if you can!)
'95 Ext Cab 3.9L Mag 4x4 Flame Red 3.55 LSD turning 30x9.50x15's
----- Original Message -----
From: <werlax@hotmail.com>
To: <dakota-truck-moderator@bent.twistedbits.net>
Sent: Tuesday, September 14, 2004 6:24 PM
Subject: Re: DML: axle flange gasket?
>
> "Bill Day" wrote:
> > They are listed at NAPA as "Front axle shaft seals" PN# 13995 @ a
> > cost of $21.49 ea.
> >
> > I know becuase I had them on my list when I dont my CV's and hub
> > assemblies and fogot to get them...
> >
> >
> Thanks for the part information. For a while now, after the truck has
been
> driven for a while, I notice a squeak in the front end. It happens with
the
> rotation of the tire, therefore it's more noticeable at slower speeds
since
> the tire isn't rotating as quickly (go figure). On a side note, I'm
working
> on the lower ball joints one of these upcoming weekends. I figured as
long
> as I'm taking things aparts I'd see if there was anything else I should
see
> about replacing in the assemblies. Thanks for any ideas and help.
> Mark
>
>
--- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.762 / Virus Database: 510 - Release Date: 9/13/2004
This archive was generated by hypermail 2b29 : Fri Oct 01 2004 - 11:38:58 EDT