No need to floor it or move the throttle when checking these values - Just
start the vehicle, let it warm up and switch into Closed Loop operation and
watch the STFT (and LTFT) readings. It shouldn't be more than +/-10%.
- Bernd
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Bob Tom
Sent: Thursday, September 16, 2004 7:02 AM
To: dakota-truck@dakota-truck.net
Subject: RE: DML: Coolant Temp Sensor, Bernd
At 12:06 AM 9/16/04, you wrote:
>And in Closed loop? - Bernd
Both show adjustments going on when in closed loop.
To clarify, I probably should have said 0 at wot, which is
one of the open loop operations. I haven't checked readings for either in
open loop operation other than wot.
Bob
This archive was generated by hypermail 2b29 : Fri Oct 01 2004 - 11:38:58 EDT