I did, it moves "a little" and with pumping builds up a little pressure, but
when bolted on, is not enough to move it... seems like air in it to me.
I have not gotten out to look at it today and see if it's any different
after sitting.
line to res is fine, worked before I removed the old one...
Thanks!
Tony.
www.helptonyout.com
Hate SPAM?
Try: www.friedspam.net
----- Original Message -----
From: Bernd D. Ratsch <fasstdak@hotmail.com>
To: <dakota-truck@dakota-truck.net>
Sent: Thursday, September 30, 2004 7:10 AM
Subject: DML: RE: how to bleed a clutch system?
>
> Tony,
>
> I've replaced mine a while ago and all I did was bolt it on and fill it.
If
> it's not disengaging the clutch, there's a few items to check:
>
> (1) Bad cylinder and/or line from reservoir
> (2) Bent or misaligned clutch engagement rod
> (3) Clutch or pressure plate damage/broken
>
> When you push the pedal, does the rod from the cylinder move? (Have
someone
> push the pedal while you watch the rod.
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@bent.twistedbits.net
> [mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Tony Troidl
> Sent: Wednesday, September 29, 2004 10:52 PM
> To: dakota-truck@dakota-truck.net
> Subject: DML: how to bleed a clutch system?
>
>
> Hi,
>
> I had to replace the slave cyl on my '97 and though I tried to remove as
> much air as possable, I am still unable to pump up the clutch enough to
make
> it work...
>
> I had understood it was saposed to be "self bleeding" so I left it
overnite
> to see if the air will work it's way up any out, but somehow doubt it...
>
> Any ideas?????
>
> Thanks!
>
>
> Tony.
>
> Hate SPAM?
> Try: www.friedspam.net
>
This archive was generated by hypermail 2b29 : Fri Oct 01 2004 - 11:38:59 EDT