I have a vise and could not get mine out...I took it and had them pressed
out and the new ones pressed in. They were a bear.
Rascal
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of mike kulczycki
Sent: Saturday, October 16, 2004 3:28 PM
To: dakota-truck@dakota-truck.net
Subject: DML: Pressing out U-Joints??
All right, I got my driveshaft out after some persuasion. Now how do I push
out the U-joints?? The fsm and haynes say to put in a vice, big pipe on end
and socket on the other to push it through. After much wrenching I can't
get it to budge. Any tips on getting them out?? They are almost 11 years
old and 143k miles. I figure if I can't get them out I'll have to take it
in to have them pressed out...
Thanks..
Mike K
94 SLT,CC,239,2wd,auto
95 Sport,RC,360,5-speed
http://www.hornok.com/zig
This archive was generated by hypermail 2b29 : Mon Nov 01 2004 - 10:47:43 EST