The only way i've seen it done is in a vice, with a socket and big
hammer/mini sledge.
And since yours are pretty old, i'd think it's going to take a lot of
hammering... ;)
The Adam Blaster
Two words, figure it out.....
>
>
>All right, I got my driveshaft out after some persuasion. Now how do I
>push out the U-joints?? The fsm and haynes say to put in a vice, big pipe
>on end and socket on the other to push it through. After much wrenching I
>can't get it to budge. Any tips on getting them out?? They are almost 11
>years old and 143k miles. I figure if I can't get them out I'll have to
>take it in to have them pressed out...
>Thanks..
>
>
>
>Mike K
_________________________________________________________________
Don’t just search. Find. Check out the new MSN Search!
http://search.msn.click-url.com/go/onm00200636ave/direct/01/
This archive was generated by hypermail 2b29 : Mon Nov 01 2004 - 10:47:43 EST