""Suter, Rick"" <RSuter@bizfon.com> wrote in message
>
> I've seen the notes about removing the rivets. Is a press also needed to
remove the upper ball joints on a '99?
>
You shouldn't need a press. Once you remove the rivets the upper should
just fall off. On my 2k, it's just riveted to the top of the control arm.
The lower is inside a sort of pocket, but easily slides out once the rivets
have been removed.
-- - Josh Lowered 2000 Dakota CC 3.9L Above Statement Not True ^^^^^ www.omg-stfu.com
This archive was generated by hypermail 2b29 : Tue Feb 01 2005 - 00:18:31 EST