> Earlier Chris told me what wire I need to tap into from the brake
> pedal harness, so I'll test it first. I'm worried about using
> the brake light circuit for fear of not knowing whether it's
> involved in the operation of the hazard lights.
That's a good point. I don't know how the pedal switch is hooked
up, but it's *possible* that that switch is hooked straight to the
lamps. You should do some checking: get a volt meter and figure
out which way the switch works, then turn the hazards on and check
the switch again so see if there is a pulsing voltage on it in
sync with the flashing.
eric
-- 1974 Valiant 4-door, 318 1999 Dakota Ext Cab, 2WD
This archive was generated by hypermail 2b29 : Wed Jun 01 2005 - 05:44:46 EDT