It's for the 4WD indicator lamp. Steve
>From: Dan Kramarsky <dkramarsky68@yahoo.com>
>Reply-To: dakota-truck@dakota-truck.net
>To: dakota-truck@dakota-truck.net
>Subject: DML: Strange 2-pin connector. What is it?
>Date: Mon, 2 Jan 2006 12:50:18 -0800 (PST)
>
>
>ok, this may seem strange but I have an unidentified connector hanging
>from the wiring
>harness. nothing is connected to it. and it has got me curious as to what
>its for.
>
>ok. this connector has just 2 contacts. it's in the wiring harness behind
>the
>alternator. in fact, it comes from the some main harness connector that
>sits on the
>passenger-side valve cover as the IAT and the Coolant temp sensor and the
>ECT sender do.
>
>the wire colors and sizes are...
> #1 wire: Light-green with Brown tracer 18AWG
> #2 wire: Black with white tracer 18AWG
>
>The connector style is 2-conductor "parallel blade" and is identical to the
>one used for
>the hood lamp disconnect. ( the connector I talking about here is on the
>firewall near
>the hinge and goes to the hood. )
>
>
>So, with all that said, does anyone know what it could be for?
>I looked in the FSM. No luck. Couldn't find anything about it.
>
>-dan
>
>
>Dan K.
>'92 Grey Dak CC, 318, 4x2, 46RH, 3.55 rear, 235/75R15, PS, PW, PB, PL, AC.
>
>Mods: Cool air, K&N oil/air, 180* T-Stat, Autolite 3924s, re-located
>IAT, Trans-Go shift kit.
>
>Future: Swap motor for a slightly modified Magnum 5.9L engine.
>
>
>
>
>__________________________________
>Yahoo! for Good - Make a difference this year.
>http://brand.yahoo.com/cybergivingweek2005/
>
This archive was generated by hypermail 2b29 : Wed Feb 01 2006 - 20:27:15 EST