Terrible Tom <SilverEightynine@aol.com> wrote:
: Dan Kramarsky wrote:
:> Help:
:>
:> Does anyone have or knows where to buy a pre-made 3" over-axle, mandrel-bent, tail pipe
:> for the GenII Club Cabs?
:> ( 131" wheel base truck )
:>
:> This would be a "Side Exit" pipe. Exiting in the stock location. (just behind the
:> right-side rear wheel)
:>
:> I have a new muffler I got from somebody local that was selling it. It's a DynoMax 3"
:> in/ 3" out.
:>
: I'd prolly hit an exhaust shop and have them bend up a pipe for it.
: Might not be the cheapest method - but prolly would be the most simple.
Unfortunately, most exhaust shops are only going to have a compression
bender, as opposed to the mandrel deal, so if Dan is looking to stick
with mandrel bends, that might not work for him. Dan, you might have some
luck with Gibson; they sell 3" cat-backs, I'm not sure if they will sell
the tailpipe tubing separate from their mufflers, but it doesn't hurt
to ask. A while back, Summit was selling mandrel bent cat-backs for
super cheap prices (about $100), but they were 2.75" as opposed to 3",
IIRC.
--
-Jon-
.- Jon Steiger --- jon@dakota-truck.net or jon@jonsteiger.com -.
| 67 Dodge Coronet, 70 Plymouth Barracuda, 76 Peugeot TSA |
| 78 Dodge B100, 90 Dodge Dakota Convertible, 92 Dodge Ram 4x4 |
| 96 Dodge Dakota, 96 Suzuki Intruder 1400, 96 Kolb FireFly |
| 99 Jeep Cherokee 4x4, 2001 Dodge Ram 3500 CTD |
`--------------------------------- http://www.jonsteiger.com --'
This archive was generated by hypermail 2b29 : Wed Feb 01 2006 - 20:27:15 EST