The cat-back system I purchased from Flowmaster came with a 3" manderal bent
tailpipe. Another place to try to see if you can just get the pipe.
Dave Clement
99 SLT+ CC 4x4
In article <dq70jd$vra$1@bent.twistedbits.net>, jon@dakota-truck.net writes:
>
>
> Terrible Tom <SilverEightynine@aol.com> wrote:
>
> : Dan Kramarsky wrote:
> :> Help:
> :>
> :> Does anyone have or knows where to buy a pre-made 3" over-axle,
mandrel-bent, tail pipe
> :> for the GenII Club Cabs?
> :> ( 131" wheel base truck )
> :>
> :> This would be a "Side Exit" pipe. Exiting in the stock location. (just
behind the
> :> right-side rear wheel)
> :>
> :> I have a new muffler I got from somebody local that was selling it. It's
a DynoMax 3"
> :> in/ 3" out.
> :>
>
> : I'd prolly hit an exhaust shop and have them bend up a pipe for it.
> : Might not be the cheapest method - but prolly would be the most simple.
>
>
> Unfortunately, most exhaust shops are only going to have a compression
> bender, as opposed to the mandrel deal, so if Dan is looking to stick
> with mandrel bends, that might not work for him. Dan, you might have some
> luck with Gibson; they sell 3" cat-backs, I'm not sure if they will sell
> the tailpipe tubing separate from their mufflers, but it doesn't hurt
> to ask. A while back, Summit was selling mandrel bent cat-backs for
> super cheap prices (about $100), but they were 2.75" as opposed to 3",
> IIRC.
>
> --
> -Jon-
>
> .- Jon Steiger --- jon@dakota-truck.net or jon@jonsteiger.com -.
> | 67 Dodge Coronet, 70 Plymouth Barracuda, 76 Peugeot TSA |
> | 78 Dodge B100, 90 Dodge Dakota Convertible, 92 Dodge Ram 4x4 |
> | 96 Dodge Dakota, 96 Suzuki Intruder 1400, 96 Kolb FireFly |
> | 99 Jeep Cherokee 4x4, 2001 Dodge Ram 3500 CTD |
> `--------------------------------- http://www.jonsteiger.com --'
This archive was generated by hypermail 2b29 : Wed Feb 01 2006 - 20:27:15 EST