Re: Update2: Stalled/wont start

From: m.meyerhoff@mchsi.com
Date: Mon Feb 06 2006 - 15:35:44 EST


With the new dizzy pickup in, no change.

Moving along I found the crank position sensor to have resistance between B&C which the FSM says is replacment time. Hope I can find one instock

Thanks guys, I will update if fixed.

mm

 -------------- Original message ----------------------
From: m.meyerhoff@mchsi.com
> Ok, Fuel filter was fine but due for a change anyway.
>
> Spark plugs looked excellent with no deposits, little wear, and a good color.
> Plug wires, one of my taylor wires lost its female connector when I pulled on
> it. I swapped a spare in. The cap had some wear, but it wasn't bad enough to
> be the cause of a sudden no start = replaced
>
> I did notice there was oil on the dizzy signal generator (the actuall sensor,
> not the plate). The FSM says that no signal from the dizzy signal gen can
> affect the ASD(auto shut down). I've had a spare one sitting around here for a
> couple of years now. I will put it on and see what happens. But, if the oil
> isn't normal how did it get there and what do I need to do to remedy?
>
> Mike

.
.
.------------------------------------------------------------------.
| Make your plans NOW to attend the National DML Meet in Colorado! |
| Date: July 15-23, 2006 - More info: http://meet.dakota-truck.net |
`------------------------------------------------------------------'



This archive was generated by hypermail 2b29 : Mon Mar 20 2006 - 10:38:58 EST