I removed the drivers seat in my 98 a long time ago to run a CB antenna
cable and I seem to recall that the seat frame and the center console were
welded together. I had to use my air chisel to break the spot welds. A
ratchet wrench also helps in there to loosen the bolts. Its either that or a
lot of patience and a regular box wrench. Anybody else have a similar
experience or am I mistaken about the welds?
Ray Irons
Dover,DE (for now, but I'm California bound!)
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net]On Behalf Of Alberto Aguirre
Jr
Sent: Wednesday, March 08, 2006 11:37 AM
To: dakota-truck@dakota-truck.net
Subject: DML: Middle Seat 40/20/40
Is it really necessary to remove the 2 bucket seats to
remove the middle console? I cant seem to get a
ratchet under the seat to unbolt it. I need to take
measurements of distance between factory bolt
locations for a custom speaker box/console I have
envisioned to make.
.
.
.------------------------------------------------------------------.
| Make your plans NOW to attend the National DML Meet in Colorado! |
| Date: July 15-23, 2006 - More info: http://meet.dakota-truck.net |
`------------------------------------------------------------------'
.
.
.------------------------------------------------------------------.
| Make your plans NOW to attend the National DML Meet in Colorado! |
| Date: July 15-23, 2006 - More info: http://meet.dakota-truck.net |
`------------------------------------------------------------------'
This archive was generated by hypermail 2b29 : Sun Apr 02 2006 - 18:27:15 EDT