On Sat, April 15, 2006 6:35 pm, Terrible Tom wrote:
>
> On the two wheel drive Daks there is no hub and bearing assembly. The
> "hub" is actually the rotor. The bearings are set in the rotor. All you
> should have to do is remove the center spindle nut and it should come
> off if I remember correctly.
On a Gen III 2wd truck the bearing is a sealed unit and the rotor slips on
over it.
-- - Josh www.omg-stfu.comThis message has been brought to you by the American Kneejerk Coalition for Equality, Compassion, and the Restoration of Karmic Unity of Self And Other Silly Hippy Happy-Swell Gayness Bullshit, or AKCECRKUSAOSHHSGB for short.
. . .------------------------------------------------------------------. | Make your plans NOW to attend the National DML Meet in Colorado! | | Date: July 15-23, 2006 - More info: http://meet.dakota-truck.net | `------------------------------------------------------------------'
This archive was generated by hypermail 2b29 : Mon May 01 2006 - 09:38:05 EDT