On Sat, April 15, 2006 11:52 am, DAKSY wrote:
>
> If you're talking about the bearing/hub assembly, I believe it IS pressed
> into
> the knuckle. I couldn't get the passenger side off the DAKSY...I hadda pay a
> local indy to
> do it. BTW, the bearing/hub assembly runs about $150 +/- US...
> HTH,
The bearing is NOT pressed onto the spindle. There's a huge nut with a
nylock ring that says "do not re-use" that holds it on. Once that nut is
removed the bearing should slide off the spindle very easily.
-- - Josh www.omg-stfu.comThis message has been brought to you by the American Kneejerk Coalition for Equality, Compassion, and the Restoration of Karmic Unity of Self And Other Silly Hippy Happy-Swell Gayness Bullshit, or AKCECRKUSAOSHHSGB for short.
. . .------------------------------------------------------------------. | Make your plans NOW to attend the National DML Meet in Colorado! | | Date: July 15-23, 2006 - More info: http://meet.dakota-truck.net | `------------------------------------------------------------------'
This archive was generated by hypermail 2b29 : Mon May 01 2006 - 09:38:05 EDT