So the bushing is just glued into the manifold?
And if pulled on hard enough the bushing will come
out?
THANKS!
--- "Bernd D. Ratsch" <bernd@dodgetrucks.org> wrote:
>
> Cut the head of the bolt off, heat up the bushing,
> pull it out, insert a new
> bushing (dealer item) with an epoxy.
>
> - Bernd
>
> -----Original Message-----
> From: Kyle Kozubal [mailto:solocamxt@sbcglobal.net]
> Sent: Friday, September 14, 2007 9:22 AM
> To: DML
> Subject: DML: HO Manifold Problem
>
>
>
> I bought an HO manifold with a TB attached, for a
> mere
> $55.00......
>
> I was taking the TB off of the manifold, when the
> upper right bolt started getting hard to turn, and
> then it just started spinning.
>
> Looking more closely at the bolt, I found that the
> bushing (that is set into the plastic mounting area
> on
> the manifold) is just spinning in place.
>
> Any ideas what I can do to save it, get the bolt
> out,
> and make the bushing stop spinning?
>
> Thanks for any and all info!
>
> Kyle
>
>
>
>
This archive was generated by hypermail 2b29 : Tue Oct 02 2007 - 15:23:18 EDT