You can get LED's with resistors built in.
- Bernd
-----Original Message-----
From: Steve Preston [mailto:steveophonic@yahoo.com]
Sent: Saturday, February 02, 2008 10:33 PM
To: dakota-truck@dakota-truck.net
Subject: RE: DML: RE: MDS "on" LED...
LED's are so voltage sensitive,they'll fry if you feed
them with anything more than a couple volts (without a
resistor). The size of the resistor depends on the
voltage source you have.
The circuit I'm drawing off of will also appreciate
the current limiting of the resistor (less chance of
pulling too much and affecting something).
Thanks!
Steve P.
This archive was generated by hypermail 2b29 : Sun Mar 02 2008 - 02:10:09 EST