1. With the polarity reversed, the speaker cone pushing the sound backwards
instead of out.
2. You have to match the impedance of the speakers to the impedance of the
output (Maximum Power Transfer Theorem)
David C. Wilker Jr.
USAF (RET)
----- Original Message -----
From: "GMBlows GMBlows" <gmblows@msn.com>
To: <dakota-truck@dakota-truck.net>
Sent: Friday, April 25, 2008 6:21 PM
Subject: Re: DML: Re: RE: speaker install
>
>
> Just an update,
> I have all four installed, correct polarity.
> It sounds OK. Not quite as much bass as the stockers.
> I left the infinity tweeters wired in the door, they work fine.
> Even though they are both wired reverse polarity, from the factory!
> If these blow out I'll spend the $200 on the infinity speakers next time.
>
> Thanks for helping me out
> Marc
>
> ----- Original Message -----
> From: "Eric" <huffy340@gmail.com>
>
>> From my 99 FSM:
>>
>> I think you have the MID-LEVEL/PREMIUM setup:
>>
>> **** Right door:
>> - LB/BK at the speakers
>> Woofer +: LB/RD at speaker, then VT for the next three sections
>> Tweeter+: Can't tell if it is LB/RD or VT
>>
>>
>> **** Left door:
>> - LG/DG
>> + : LG/VT
>>
>>
>> **** Rear Left
>> + BR/YL
>> - BR/LB
>>
>> **** Rear Right
>> + DB/WT
>> - DB/OR
>> Eric
>>
>>
>
This archive was generated by hypermail 2b29 : Thu May 01 2008 - 00:37:46 EDT