The speakers I used are 4-ohm, I don't know what the factory ones are.
However, the infinity aftermarket speakers are 2-ohm.
----- Original Message -----
From: "Dave Wilker" <wilkerbeast01@charter.net>
To: <dakota-truck@dakota-truck.net>
Sent: Friday, April 25, 2008 9:32 PM
Subject: Re: DML: Re: RE: speaker install
>
> 1. With the polarity reversed, the speaker cone pushing the sound
> backwards
> instead of out.
> 2. You have to match the impedance of the speakers to the impedance of the
> output (Maximum Power Transfer Theorem)
>
>
>
> David C. Wilker Jr.
> USAF (RET)
>
>
> ----- Original Message -----
> From: "GMBlows GMBlows" <gmblows@msn.com>
> To: <dakota-truck@dakota-truck.net>
> Sent: Friday, April 25, 2008 6:21 PM
> Subject: Re: DML: Re: RE: speaker install
>
>
> >
> >
> > Just an update,
> > I have all four installed, correct polarity.
> > It sounds OK. Not quite as much bass as the stockers.
> > I left the infinity tweeters wired in the door, they work fine.
> > Even though they are both wired reverse polarity, from the factory!
> > If these blow out I'll spend the $200 on the infinity speakers next
> > time.
> >
> > Thanks for helping me out
> > Marc
> >
> > ----- Original Message -----
> > From: "Eric" <huffy340@gmail.com>
> >
> >> From my 99 FSM:
> >>
> >> I think you have the MID-LEVEL/PREMIUM setup:
> >>
> >> **** Right door:
> >> - LB/BK at the speakers
> >> Woofer +: LB/RD at speaker, then VT for the next three sections
> >> Tweeter+: Can't tell if it is LB/RD or VT
> >>
> >>
> >> **** Left door:
> >> - LG/DG
> >> + : LG/VT
> >>
> >>
> >> **** Rear Left
> >> + BR/YL
> >> - BR/LB
> >>
> >> **** Rear Right
> >> + DB/WT
> >> - DB/OR
> >> Eric
> >>
> >>
> >
>
>
This archive was generated by hypermail 2b29 : Thu May 01 2008 - 00:37:46 EDT