Need to disable the "MAINT REQ'D" dash light.

From: Dan Kramarsky (dkramarsky68@yahoo.com)
Date: Fri May 23 2008 - 22:08:32 EDT

Next message: Brian: "RE: Need to disable the "MAINT REQ'D" dash light."
Previous message: David Gersic: "Re: RE: Help needed: O2 Sensor part numbers"
Next in thread: Brian: "RE: Need to disable the "MAINT REQ'D" dash light."
Reply: Brian: "RE: Need to disable the "MAINT REQ'D" dash light."
Reply: David Gersic: "Re: Need to disable the "MAINT REQ'D" dash light."
Reply: Terrible Tom: "Re: Need to disable the "MAINT REQ'D" dash light."
Maybe reply: knox.james@sympatico.ca: "Re: Need to disable the "MAINT REQ'D" dash light."
Maybe reply: Dan Kramarsky: "Re: Re: Need to disable the "MAINT REQ'D" dash light."
Maybe reply: Dan Kramarsky: "Re: Re: Re: Need to disable the "MAINT REQ'D" dash light."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Ok, in 1992-93 Daks there is a dash light just to the right of the LOW WASHER FLUID
LAMP.

The letters on the lamp says: "MAINT REQ'D"

I can hear most of you right now are saying, "Huh?"

Well that's because in 1994 and up Daks, Chrysler disconnected this lamp and blocked it
off in the dash.

I have the complete schemetics for 1994 Daks, it says "NC" or "not connected" for the
Grey circular dash connector Pin "C". And it doesnt show any lamp in the lamp holder in
the circuit board. ( although the circuit board does have the lamp holder, just no lamp
is installed)

However, Pin "C" in the Grey connector in the 1992-93 Daks was used for this stupid
"MAINT REQ'D" light.

Q: Can someone with 1992 wiring diagrams tell me where in 50-pin bulkhead connector (
or even the PCM connector ) I can disable this light?

thanks!
-dan

Dan K.

Vehicle: 1992 Dakota Club Cab LE Color: Two-tone silver Engine: 5.2L EFI
Options: A/C, Cruise, PS, PB, PW, PL, 3.55 gear, 46RH, tinted rear slider.
Mods: Home-brew CAI, March Performance pulley set, K&N Filters, 180* T-stat, relocated IAT, DynoMax Super Turbo Exhaust Kit, Hi-Flow Cat, Autolite plugs & wires, Gates hoses & belts.
Photo: http://static.flickr.com/42/84856795_c18903d10f.jpg
Whats Next: Mopar Performance PCM, 3.91 rear gear with LSD, electric fan, KYB shocks, re-paint body, 2/4 drop kit.

Next message: Brian: "RE: Need to disable the "MAINT REQ'D" dash light."
Previous message: David Gersic: "Re: RE: Help needed: O2 Sensor part numbers"
Next in thread: Brian: "RE: Need to disable the "MAINT REQ'D" dash light."
Reply: Brian: "RE: Need to disable the "MAINT REQ'D" dash light."
Reply: David Gersic: "Re: Need to disable the "MAINT REQ'D" dash light."
Reply: Terrible Tom: "Re: Need to disable the "MAINT REQ'D" dash light."
Maybe reply: knox.james@sympatico.ca: "Re: Need to disable the "MAINT REQ'D" dash light."
Maybe reply: Dan Kramarsky: "Re: Re: Need to disable the "MAINT REQ'D" dash light."
Maybe reply: Dan Kramarsky: "Re: Re: Re: Need to disable the "MAINT REQ'D" dash light."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Mon Jun 02 2008 - 00:18:53 EDT