Bernd, do you know who makes Mopars ball joints for them ?
I can get Moog uppers for $128ea, Dealer $95ea,
Moog lowers for $141ea, Dealer $130ea. I`m assuming the
dealer lowers are greaseable.
Powerslot rotors for $135ea. Dealer $95ea, ( that have lasted 100,000
kms.)
Thanks,
~ Jay
---- Original Message -----
From: "Bernd D. Ratsch" <bernd@dodgetrucks.org>
To: <dakota-truck@dakota-truck.net>
Sent: Tuesday, August 12, 2008 5:07 PM
Subject: DML: RE: Ball Joints & rotors
>
>
> Yup...grab the MOOG set - much better as they allow you to grease them on
> a
> regular basis. On the bearing...it's a hub assembly, not a simple
> bearing/race assembly so yes...it costs more.
>
> Good aftermarket rotors are about $90US so the $95CDN isn't that bad. Be
> prepared for higher price on the powerslots though (and beware of the
> cheap
> aftermarket slotted look-a-likes).
>
> - Bernd
>
> -----Original Message-----
> From: Jay & Dana [mailto:jay&dana@telus.net]
> Sent: Tuesday, August 12, 2008 6:41 PM
> To: DML
> Subject: DML: Ball Joints & rotors
>
>
> On one of my previous posts, I was right about the driver's side wheel
> bearing, it was shot. Dealer charge was $283.00 cdn for the bearing. I
> questioned them and they said since it was a 4x4 it was a special sealed
> unit, (of course :-)
>
> They also said that my upper and lower ball joints and both brake rotors
> should be replaced soon. What do you guys think about $130.00CDN each for
> the lower ball joints, $90.00CDN each for the upper ball joints (Mopar non
> greaseable of course) ,and $95.00CDN each per rotor? They said the
> originals couldn't be turned but they don't look that bad to me.
>
> I think I will be going to NAPA tomorrow and price out the Moog ball
> joints
> (anyone have any part numbers? ). Then to Lordco Auto Parts to price out
> the Powerslot rotors (part #'s ? ) This is for my 97, CC, 318, 5 speed
> Dak.
>
> Thanks for any feedback guys,
>
> -Jay
>
>
>
>
This archive was generated by hypermail 2b29 : Fri Sep 05 2008 - 15:32:20 EDT