Thanks Azie....I'm all set. Good advice.
Bob
On Sun, Dec 12, 2010 at 6:23 PM, maggie11@mchsi.com wrote:
> BOB writes:
>
> Hey Guys...
>
> I have an electrical problem
>
> I was doing some wiring of a new underhood fuse block with a coule
> relays for my elec fan and inverter...
>
> Everything was fine and when I went back to turn the key to on to
> check my fan operation....everything was dead. I looked at my under
> hood large fuses and found the 40 AMP ING SW (number 7) to be blown. I
> replaced it and I believe it blew again. I then moved 40 AMP ING SW
> STARTER (number 8) to the number 7 spot on still no start. I believe
> you need both of those fuses to start.
>
> The very odd thing is ........Now with number 7, 8 & 9 (ABS PUMP)
> out, I turned my ignition switch to the on position and on the way
> back to off the horn beeped
>
> The switch was off and the horn continued to blow until I disconnected
> the + wire that feeds the fuse box....... WTF
>
> Tomorrow I will replace all 3 fuses but what would cause the horn to
> blow continuois???
>
> This did happen with my 10 amp battery charger hooked up charging my
> main battery.
>
> I disconnected all my battery's in case of a short.....
>
> Anyone have any idea's..... Jon?
>
> Well I'm not Jon but the 1st thing I'd do is disconnect the additional
> wiring I just installed..Usually when we do modifications and
> encounter
> problems such as you're experiencing the problem lies within the
> confines of the mods we just completed.. If the problem still exist
> after undoing the mod, obviously there is another problem that you
> will just have to trace out..
> Good luck
> Azie
This archive was generated by hypermail 2b29 : Sat Jan 01 2011 - 16:31:13 EST