From: ljacobs@calvin.uchsc.edu@INTERNET on Mon, Mar 25, 1996 10:53 AM
>I have my eye on these 'projector' driving lights, and since there is
>no way to put lights on the Dakota (short of buying roll bar, push bar,
>or light bar) I'd like to do the following:
>Drill round holes in the front 'spoiler' (plastic, should be easy)
>where the frame comes up to the front. Install the projector lenses
>where they are just about flush and peek through the holes. I think
>this would make a sharp setup, and one hole through the frame would make
>a very solid mount.
>Parking stops and rocks being thrown up aside, do you think this is
>very feasable ??
Sounds good to me!! I suggest that you get a hole saw at the hardware store that
is slightly larger than the light. With a little sanding afterwards you will get
a nice clean looking hole.
Dave Clement
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:21 EDT