Re: valve cover gaskets...

From: Chip Maurer (chip@unx.dec.com)
Date: Wed Apr 09 1997 - 17:16:16 EDT

Next message: Bruce Bexte: "[Fwd: wind whistle]"
Previous message: Andre Mauboussin: "Re: 180 thermostat; cold plugs"
In reply to: Alan Casey: "Re: valve cover gaskets..."
Next in thread: L. J. Morris: "Re: valve cover gaskets..."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Alan Casey wrote:

> Guys, Guys. We are talking about valve cover gaskets, are we not? If so
> whats going to blow out? Theres no preasure against them. Some of my bolts
> were only finger tight when I took them out. I put the old ones right back
> on and just barely tightened them down. No problem, no leaks.

I can see you've never had an Explorer...

>
> Hope this helps.
> Alan...
>

-- 
+-------------------------------------------------+
| Chip Maurer       Digital Equipment Corporation |
| chip@unx.dec.com  200 Route 9 North             |
| (908) 577-6195    Manalapan, NJ 07726           |
+-------------------------------------------------+

Next message: Bruce Bexte: "[Fwd: wind whistle]"
Previous message: Andre Mauboussin: "Re: 180 thermostat; cold plugs"
In reply to: Alan Casey: "Re: valve cover gaskets..."
Next in thread: L. J. Morris: "Re: valve cover gaskets..."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:37 EDT