You can't draw any more air than what the throttle body will allow in.
There should be no problem for the stock exhaust system to handle it.
While on this subject. I read with interest all the mods everyone is doing
to their air cleaners. All the open element filters, flipped top covers
etc. This is all old 1950-60 technology to increase air flow. You may
think your getting an increase in performance (and you might get a little)
but I think your just getting more noise than performance gains. First,
your sucking hot under-hood air into the engine which everyone knows is
less dense and produces less power that higher density cool air your
original system was drawing in from the front of the engine! I would think
that opening up, but retaining, the original air system to allow more air
in would be the best way to go. Like maybe the following:
1) Install K&N filter in original housing
2) Remove original air horn from housing and replace with larger fabricated
unit.
3) Install larger diameter tubing to fit new air horn.
4) Rework or replace front air intake to fit new tubing
Even with these mods your engine can only draw in as much as the throttle
will allow. If you increase the throttle body size then the exhaust will
be the restriction. If you increase the exhaust then the Cam will need to
be changed. It goes on and on until your wallet is empty and your wife
and kids are gone!
My $.02 ($.014 Canadian)
----------
> From: Keith R Wanderi <keith.wanderi@fsg.deluxe.com>
> To: 'dakota@ait.fredonia.edu'
> Subject: RE: K&N clone
> Date: Tuesday, April 15, 1997 1:20 PM
>
> I went to the local auto parts store last Saturday to pick up a K&N
> replacement for my 97 V6. They told me that it's not available yet?? I
> told them that I heard that it was the same filter the Ram used, #
33-2084.
> His book showed that the 97 Dakota V6 and V8 used the same filter, but
not
> the same as the Ram. I have a Jegs and Summit catalog and neither list a
> 97 Dakota under K&N filters. Does anyone know the real scoop on K&N and
a
> 97 Dakota?
>
>
> ----------
> From: tnadoman@ix.netcom.com
> Sent: Tuesday, April 15, 1997 10:52 AM
> To: dakota@ait.fredonia.edu
> Subject: K&N clone
>
> Hello again to all!!
>
> To those who installed a K&N clone on their '97 Dakota V8's, with all the
> increase of air into
> the engine, are their any problems with it exiting the exhaust?
>
> Specifically, is there an increase in back pressure on the muffler(stock)
> with the extra air that
> being pulled into the engine.
>
> Dave Thede
> '97 Dakota Sport CC V8
> K&N replacement filter
> K&N clone???
>
>
>
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:37 EDT