At 11:08 PM 6/22/97 -0500, you wrote:
>i wanted mine to exit before the rear wheel as well, but the frame doesnt
>allow it to work properly on my CC 2WD, because of the frame being
>straight, the pipe will hang like 2 inches off the ground, this would
>suck!. so i opted for rear exit at the right rear corner coming out at an
>angle with my oval megs tip.
I worried about the frame clearance too, especially since I'm considering a
3"/3" drop. I'm installing a 3" turndown before the axle. I kinda like
the clean look of seeing no tailpipe exit.
*******************************97 Dakota Sport*******************************
sean meldrum
email: Home: spm@c3net.net (list subscription)
Work: sean_p_meldrum@auto.ittind.com
Black, 318, 5spd, 3.55SG, reg. cab, 2wd, buckets
"Fresh air by Meldrum"
All exterior vinyl graphics removed
Moroso Blue Max plug wires and Spectre looms
NO muffler, exhuast exiting b4 axle (temporary until I decide on a muffler)
MSD 6a, Blaster coil awaiting installation
****************************************************************************
****
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:45 EDT