In a message dated 97-07-13 13:27:24 EDT, you write:
<< I noticed at one point he mentioned reading about enlarging the throttle
bores to 80mm. I think the correct statement is enlarging the bores .080"
additional. This would take the stock twin 48mm bores to twin 50mm.
Exactly what he did. The article I read stated that any more than this
might put you completely off the stock fuel map. >>
that was the other thing....i didn't shave anywhere where the throttle plates
touch the throttle body.......i know if they don't sit right it screws up
stuff......so what did the guy do?? put in new throttle plates??
RTuss
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:48 EDT