Re: 'puter chip

From: Sean Meldrum (spm@c3net.net)
Date: Sun Jul 13 1997 - 17:03:36 EDT


At 04:50 PM 7/13/97 -0400, you wrote:
>Has anyone checked with Mopar lately? I just got the following info from my
>father-in-law. Maybe they are not out yet...but they must be getting close.
> He is VERY up to date with vehicle info ... so I am sure he got this from a
>good source:
>
>FYI - I found something that may be of interest to you. Mopar Performance is
>marketing a replacement engine control module for the 5.2 & 5.9 litre trucks
>that boosts horsepower by approx. 24 and adds another 25 ft./lbs of torque
>(on the 5.2 litre engine). It's a plug in module that directly replaces the
>stock module. It is rather expensive - $259.75 and after installation, it
>requires the use of super unleaded fuel with an octane rating of 92 or
>better. Gotta go to work...this is the last night thank goodness.
>
>If anyone has any info.....let me know...
>
>Ken
>

This is simply the SBEC. Last word is October. Awaitng CARB approval.
JET will beat 'em to market probably.
*******************************97 Dakota Sport*******************************
  sean meldrum

email: Home: spm@c3net.net (list subscription)
                  Work: sean_p_meldrum@auto.ittind.com

Homepage: http://www.geocities.com/MotorCity/Downs/7875/

 Black, 318, 5spd, 3.55SG, reg. cab, 2wd, buckets
"Fresh air by Meldrum"
All exterior vinyl graphics removed
Moroso Blue Max plug wires and Spectre looms
DynoMax Race Magnum Welded. 3" in/out, exiting before axle.
MSD 6a, Blaster coil awaiting installation
****************************************************************************
****



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:48 EDT