In a message dated 97-07-13 22:36:56 EDT, you write:
<< No, although that *is* done on some tbi mods. The article I read simply
did the .080" cleanup which is exactly what we've been talking about and/or
doing. Increase 48mm bore to 50mm. >>
ok so how do i do this??? obviooulsly noty get a 50 mil drill
bit........today i took all the ridges out of the top of the throttle body
and and kinda smoothed them into the ports a bit.......i had no MIL lamp and
it ran fine so obvioulsy that did no good (i think).......maybe i'll just
remove the throttle body all together and let it run at full throttle......;)
Russ
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:48 EDT