In a message dated 97-07-14 20:20:37 EDT, you write:
<< Slide your finger down the side wall of the throttle bore towards the
butterfly. You'll reach a point where the bore opens up and has a polished
finish. This is the "ridge". >>
yeah i saw that....now i need to pull mine back off again and do that......so
if i open it up a bit the throttle plates will still seal up ok?? or is that
way it will run like garbage at first?? remeber mines is a v-6 so i think
opening mine to 50 mils is a little exseeive.....i was thinking of using a
hone to do it......that way they would be straight...
Russ
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:48 EDT