At 11:09 AM 7/20/97 +0900, you wrote:
> I was kind of curious about this mod. Is the TBI coated with
>anything to keep it from getting any kind of corrosion on it? And if
>you port the TBI will this strip some of the coating off of it and
>cause corrosion in the ports? I realize that the TBI is probably
>aluminum or some mix of metals. Although with the injectors being
>right there maybe the gasoline will keeps them preserved in some
>way. Then again maybe I have no clue as to what I am talking
>about... hahahahah ; -)
> Reason I ask all this is because I have real non-coated aluminum
>rims on my RX-7 over here and man are they a pain to keep clean.
>They seem to corrode within 2 days of a good wash and polish.
> By the way... did you guys see the new Pro-Stock Dodge Dakota on
>NHRA Today on TNN? Wow!! Very sharp... can't wait to see it run....
>
>Shawn
>
Not sure about the coating. Don't *think* there's anything on there. I'm
going to look into some sort of sealant though anyway. The injectors are a
multi-point setup.....one per cylinder at the base of the manifold.
The Dak was on today???!!! Arrgghhh! I worked today....damn. I hope the
show tomorrow is the same one replayed. I've been itchin' to see that thing!
*******************************97 Dakota Sport*******************************
sean meldrum
email: Home: spm@c3net.net (list subscription)
Work: sean_p_meldrum@auto.ittind.com
Homepage: http://www.geocities.com/MotorCity/Downs/7875/
Black, 318, 5spd, 3.55SG, reg. cab, 2wd, buckets
"Fresh air by Meldrum"
All exterior vinyl graphics removed
Moroso Blue Max plug wires and Spectre looms
DynoMax Race Magnum Welded. 3" in/out, exiting before axle.
MSD 6A & Blaster 2 coil w/ chrome cover
****************************************************************************
****
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:48 EDT