On Wednesday, August 06, 1997 5:03 PM, WillTier@aol.com
[SMTP:WillTier@aol.com] wrote:
> In a message dated 97-08-04 21:37:40 EDT, you write:
>
> << The universals aren't bad Bill. If you installed that nitrous kit you
can
> do the wires with yer eyes closed. Just takes a couple to get the hang
of
> it. Have some dielectric grease or lubricant handy to make it easier to
> slip the boots over the terminals. >>
>
> Is there a tool to put the ends on that don't come on and is it included
or
> what is the procedure for putting the ends and boots on and is it a good
> connection ?
>
> Bill
>
The MSD kit includes a tool, but i used my own tools, but their tool works
pretty well. And like the above says....USE DIELECTRIC GREASE!!! both for
the benefits of electrical conduction, but also to make those littles
suckers slide on!!!
Randy E. Bowman r.bowman@cvce.com
President
Catawba Valley Computer & Electronics, Inc.
http://www.cvce.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:50 EDT