Re: FABM for the R/T

From: Jon Steiger (stei0302@cs.fredonia.edu)
Date: Tue May 19 1998 - 22:22:18 EDT

Next message: jim miller: "Re: Attention to everyone read this. You'll want to, trust me."
Previous message: Jon Steiger: "Re: roller rocker article"
In reply to: Sean_Meldrum@ittauto.com: "FABM for the R/T"
Next in thread: Trevor Pontbriand: "Gibson exhaust"
Reply: Trevor Pontbriand: "Gibson exhaust"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

At 07:26 AM 5/19/98 -0400, you wrote:
[...]
>I'm going to update my page to reflect these p/n's as being R/T recommended
>and I've recently been informed that Mr. Gasket makes a 10" can p/n 9791
>(comes with plastic nipple for breather hose....Edelbrock has metal
>nipple).
>

I've got a 14" Mr. Gasket can on my '96. The plastic nipple that came
with it was pretty cheezy though, so I just widened up the hole a little
bit and used the (much higher quality) nipple from my stock air can.

-Jon-

  .--- stei0302@cs.fredonia.edu -- http://www.cs.fredonia.edu/~stei0302/ ---.
  | DoD# 1038, EAA# 518210, NMA# 117376, USUA# A46209, KotWitDoDFAQ, RP-SEL |
  | '96 Dodge Dakota v8 SLT Club Cab, '96 Kolb FireFly 447 (#FF019) |
  `-------------------------------------------------------------------------'
   I do not speak for the SUNY College at Fredonia; any opinions are my own.

Next message: jim miller: "Re: Attention to everyone read this. You'll want to, trust me."
Previous message: Jon Steiger: "Re: roller rocker article"
In reply to: Sean_Meldrum@ittauto.com: "FABM for the R/T"
Next in thread: Trevor Pontbriand: "Gibson exhaust"
Reply: Trevor Pontbriand: "Gibson exhaust"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:48 EDT