It sounded more to me like you were describing the tie rod ends - same
as on my truck.
Tate
-----Original Message-----
From: Stephan Boianoff [SMTP:sboianoff@mdc.com]
Sent: Thursday, July 23, 1998 9:44 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: lubrication points - any help? -Reply
>>> "W. Jack Hilton III" <hemi@mindspring.com> 07/23/98 08:33am >>>
None on the ball joints ? check upper nd lower on both sides and
tie-rod
ends .
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
The two grease zerks that I found are on the front lower ball joints,
one
each side (I wasn't very clear about that in my original post, sorry).
The
front upper ball joints seem to be sealed. Anyone else know where
any
more are? Are there any more?
Steve
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:09 EDT