In a message dated 98-08-17 12:55:06 EDT, you write:
<< Patrick,
Do you want one of the TB's before or after I open it up??? I was
planning on using a boring bar in one of the NC mills I have access to.
I can get the 55MM plates
no problem and there only $2.00 each. Let me know.
Frank >>
Before.. I haven't checked PN#s yet, but am curious as to what years will
interchange on the Rams & Daks.. I have a 97. I'd like to get one I could test
out on my truck, but it'll work either way.
What size boring bar were you planning on using? Make sure the tool doesn't
have to extend too far out .. chattering can be a problem (which I'm sure you
already know..)
I was planning on opening them up too on one of our smaller Fadals pretty soon
..
ttyl
Patrick
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:21 EDT