At 07:49 PM 8/18/1998 -0700, you wrote:
>When you put the headers on did you follow a sequence tightening the
>bolts? Try backing the bolts off a bit and bring the header away from
>the head but don't take them off. Then push the header to the head and
>hand tighten the bolts starting from the center out to the ends. So if
>there six bolts then snug middle top, middle bottom, left top, left
>bottom, right top, right bottom making sure the header is being drawn in
>to the head everywhere. Then find out what the torque should be and go
>through the sequence again applying the proper amount of torque.
>As for the y pipe I cant help on that one.
>
>Joel
>
Jason,
Did you use those little donut metal things that came with the headers. I
think you're supposed to use 'em if the seal to y-pipe isn't very good.
Brian
"Life is what happens while
you are making other plans."
-John Lennon
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:23 EDT