50 - 100 bucks, count me in...
Chris
-----Original Message-----
From: Holloway,Frank T <Frank.T.Holloway@KP.ORG>
To: 'dakota-truck@buffnet.net' <dakota-truck@buffnet.net>
Date: Monday, August 31, 1998 7:42 PM
Subject: RE: DML: RE: RE: franks TB!!RE: Magnum Performance Throttle Body?
>DML,
>Here is where we are at with the TB's. The first one that Bruce installed
>appears to be working fine (no check engine light, or dead spots off idle).
>The next will
>have larger thinner brass throttle plates and a stainless steel throttle
>shaft installed. Hopefully he will be installing the new one the weekend of
>Sept 12th. I will be
>installing one identical to the new one for Bruce this coming weekend.
Bruce
>had some concerns about interference with the manifold and larger throttle
>plates,
>and I need to check this out on my truck (see if it is unique to Bruce's
>truck), flow numbers will follow. Additionally, I'll be running my truck on
>the dyno to check
>for power and lean conditions. If everything goes according to plan, we
>should have some additional numbers next week. Cost, we don't know yet but
>were kicking
>around a figure between $50 - $100 each, what do you think????
> Frank
>
>> -----Original Message-----
>> From: DodgeBoyz3@aol.com [SMTP:DodgeBoyz3@aol.com]
>> Sent: Monday, August 31, 1998 3:42 PM
>> To: dakota-truck@buffnet.net
>> Subject: Re: DML: RE: RE: franks TB!!RE: Magnum Performance Throttle
>> Body?
>>
>> In a message dated 8/31/98 4:23:34 PM Central Daylight Time,
>> AMok@spbank.com
>> writes:
>>
>> > How much and how do I contact Frank?
>> Ahhhh........ make that two of us!
>>
>> Gene
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:28 EDT