This "build up" is MUCH less if you can get a good brass cap, instead of the
aluminum stock unit...
>Usually you'll see "build up" on the tip of the rotor and the underside of
>the wire terminals. I use some sandpaper to remove it and return it into
>service a couple times before buying a new set.
>
>
> A few quick questions, when should these be replaced? How
>can I tell if
> mine needs replacing?
> Why go w/ a good one? Are we talking performance, or just
>general
> quality?
> Thanks a lot,
> Robert
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:10:58 EDT